DISCOFILM VINYL CARE BUNDLE
2-in-1 brush + 500 ml cleaning set – For real shine & clear sound!🎶 What's inside?
1️⃣ DISCOFILM 2-in-1 Record Brush
✅ Carbon fibers + velvet = double cleaning
✅ Antistatic – less dust, more sound
✅ Simply guide it over the rotating plate – done!2️⃣ DISCOFILM 500 ml Cleaning Set
✅ The original – proven for over 30 years
✅ Removes dust, grease, cola, beer & more
✅ For vinyl, CD/DVD/Blu-ray & DSLR sensors
✅ Apply, dry, peel off – like new!📦 Included in the bundle:
- 1x DISCOFILM brush (carbon & velvet)
- 1x DISCOFILM Cleaner (500 ml)
- 2x LP Bases
- 1x dispenser for application
💡 Perfect for:
Vinyl fans, DJs, collectors & everyone who loves their records!
DISCOFILM Vinyl Care Bundle – Complete set for cleaning and caring for vinyl records
Using DISCOFILM SET – step by step
1. Preparation
Place the record on the base.
The pin of the base element must protrude through the center hole of the plate.
Attach the applicator dish (dispenser) to the spike.
💡 Tip from Dr. DISCO:
Warm the DISCOFILM bottle beforehand in a water bath (approx. 25–30 °C). This makes the liquid more pliable and allows you to clean more record sides with one filling!
2. Apply
Pull off the cap of the DISCOFILM bottle.
Pierce the seal with a sharp object (e.g., a thorn).
Press lightly on the bottle and fill the applicator with liquid up to the fill line.
➡️ Slowly rotate the applicator clockwise over the record.
➡️ A smooth, continuous film should form, covering all grooves.
➡️ If liquid is running low, simply refill and continue the job.
➡️ Then remove the applicator.
3. Drying & Peeling
Allow the film to dry completely – approximately 2-4 hours depending on room temperature.
Now all the dirt particles are bound in the film.
📌 Here's how to peel off the film:
Stick a strip of adhesive tape approximately 5 cm long halfway onto the edge of the record.
Press it down firmly and slowly peel the film off upwards.
❗ Note:
If the film tears when you peel it off, it was probably applied too thinly. No problem – simply apply another layer and let it dry as usual.Application of DISCOFILM bottle with sponge applicator - step by step
1. Apply
Pull the cap off the DISCOFILM bottle upwards.
Carefully pierce the sealing membrane with a pointed object (e.g. a spike).
Now apply DISCOFILM evenly and generously to the record using a sponge or brush.
Make sure that a homogeneous, closed film forms over all grooves.
💡 Tip from Dr. DISCO:
Warm the DISCOFILM bottle beforehand in a water bath (approx. 25–30 °C). This makes the liquid more pliable and allows you to clean more record sides with one filling!
2. Drying & Peeling
Allow the film to dry completely – depending on room temperature, this will take approximately 2-4 hours.
Now all dust and dirt particles are bound within the film.
➡️ Stick a strip of adhesive tape about 5 cm long halfway onto the edge of the board and press it firmly onto the dried film.
➡️ Slowly and evenly peel the film upwards – using the protruding adhesive strip.
❗ Note:
If the film tears when you peel it off, it was probably applied too thinly. No problem – simply apply a new layer and repeat the process.
